England's Stove Works 55SHP22 Manuel d'utilisateur télécharger pdf

P.O. Box 206 Monroe, VA 24574 www.englanderstoves.com Phone: (800) 516-3636 Fax: (434) 929-4810

Pellet Stoves

Wood Stoves

Gas Stoves

Mult

uel

toves

Installing the PU-DTSTAT

BEFORE BEGINNING THERMOSTAT INSTALLATION BE CERTAIN

THE STOVE IS UNPLUGGED

AND COMPLETELY COOL. DEPENDING

ON WHICH STOVE THE THERMOSTAT IS BEING INSTALLED ON,

THE CONTROL BOARD MAY NEED TO BE REMOVED FOR

INSTALLATION.

1. Using a small, slotted screwdriver (often referred to as a jeweler’s screwdriver),

loosen the two screws on the front of the J18 thermostat terminal, shown below

and remove the jumper which is installed in the terminal from the factory. This

jumper should be set aside and saved.

2. Insert one of the thermostat wires into each of the terminals on the bottom of the

J18 thermostat connection block and tighten the screws on the front of the

thermostat terminal. The thermostat wires should be securely held in place by

these screws (remember that the thermostat is not polarity specific, so it will not

matter which wire goes into either terminal).

Connect

thermostat

wires here

(

J18

)

1 2 3

P.O. Box 206 Monroe, VA 24574 www.englanderstoves.com Phone: (800) 516-3636 Fax: (434) 929-4810 Pellet Stoves

Page 2

2 3. Pull the two halves of the thermostat apart so that the interior of the thermostat is visible. Install one thermostat wire into the “G” termina

Page 3

3 6. Consult the Owner’s Manual of your stove (and see the chart below) for more details on how the thermostat works with your control board to manag

Pas de commentaire

England's Stove Works 55SHP22 Manuel d'utilisateur